Ask a question

Q&A forum › Author "amorosik"
Filter:QuestionsSubscribes
Wich signals on board edge? Schematic and pcb layout are needed by all customer
Closedamorosik asked 4 months ago • 
202 views2 answers0 votes
Tx for uart1 / Rx for uart2 ?
Closedamorosik asked 4 months ago • 
232 views1 answers0 votes
How to understand if the SimpleRTK2B card is receiving the flow of the rtcm corrections?
Closedamorosik asked 4 months ago • 
335 views4 answers0 votes
Gps receiver + Radio Modem – not interfere each other?
Closedamorosik asked 4 months ago • 
230 views1 answers0 votes
Where is battery ?
Closedamorosik asked 4 months ago • 
217 views1 answers0 votes
3D / Dgnss / Float / Fixed – what meaning exactly?
Closedamorosik asked 4 months ago • 
335 views1 answers0 votes
Base + Rover – configuration text file for firmware 1.12
Closedamorosik asked 4 months ago • 
966 views3 answers0 votes
Nmea GGA sentence always 12 SV ?
Closedamorosik asked 4 months ago • 
303 views2 answers0 votes
Power board only with 3V3
Closedamorosik asked 4 months ago • 
103 views0 answers0 votes
Minimum parameters to get "rtk fixed"
Closedamorosik asked 4 months ago • 
452 views1 answers0 votes
Ho to save board configuration board and radio module configuration
Closedamorosik asked 4 months ago • 
180 views1 answers0 votes
Xbee-usb connector – How use it ?
Closedamorosik asked 4 months ago • 
150 views1 answers0 votes
'Moving base' functionality for position+heading
Resolvedamorosik asked 7 months ago • 
1184 views1 answers0 votes
Ask Question