U-Center Connection Error

Q&A forumCategory: QuestionsU-Center Connection Error
gchustz asked 4 months ago

I have been validating these simpleRTK2B in base/rover configuration for a while and the only setting I changed on the rover side was increasing the gps rate (UBX > CFG > Rate). Now I have run into the issue where I cannot access this Rover board at all through U-center nor pixhawk. Linux cat and python serial just throws a bunch of garbage from the port as well. I have tried the VCP driver as well with no luck.
Any suggestions?

gchustz replied 4 months ago

I believe you accidentally linked this thread instead of what you meant to

Ardusimple Staff replied 4 months ago

Your are right ūüôā
This is the good link https://www.ardusimple.com/simplertk2b-hack-3/