I have tried using the HW Serial port (Rx/Tx) on the arduino (since those are the pins the ardusimple uses) as well as using jumpers and to GPIO pins and using the SoftwareSerial library but I have had no luck. I’m not sure if I’m missing something with the baud rate or rate, but I have everything set to 9600 baud and 1 Hz packet rate.
- Unlike NMEA, UBX protocol is not human readable, if you send it to a terminal you will only see funny characters.
- Make sure you are stacking our board on top of Arduino UNO. If you are instead connecting wires pin to pin, check that you are enabling the Arduino rails by connecting IOREF to 3.3V.
- 9’600bps at 1Hz, if your antenna is placed outside with good sky view… might be too slow baudrate. ZED-F9P can see so many satellites that the default messages will very fast become very long.
Please login or Register to submit your answer