and 
Problem with Z precision shown
leonciosl asked 6 months ago
Problems with Z Accuracy.
After firmware upgrade, Z precission data jump from ten to ten centimeters, even when it says that Z accuracy is over 1 or 2 cms.
Where can I change it (with u-center) to get Z precision at cm or even mm level again?
After firmware upgrade, Z precission data jump from ten to ten centimeters, even when it says that Z accuracy is over 1 or 2 cms.
Where can I change it (with u-center) to get Z precision at cm or even mm level again?
2 Answers
Ardusimple Staff answered 6 months ago
Use our configuration files that have the extra digits enabled: http://www.ardusimple.com/configuration-files
Or you can enable extra decimals manually via UBX-CFG-NMEA “enable high precision mode”
Or you can enable extra decimals manually via UBX-CFG-NMEA “enable high precision mode”
Please login or Register to submit your answer
