and 
NTRIP 4G Client+ RS-232 board: changes from fixed to floating regularly ? change of baudrate)
lupko.kappert asked 2 years ago
Dear Staff,
In operation I encounter status changes fixed<>floating. 4G fieldstrength is strong, tried this with different receivers and locations. Same behaviour. Can you advice?
Change of baudrate from 115k tot 38k4 does not succeed. i changed setting in configuration file but no result. Is there a way to change baudrate with direct commands to Telit module or other way?
Thank you, regards
In operation I encounter status changes fixed<>floating. 4G fieldstrength is strong, tried this with different receivers and locations. Same behaviour. Can you advice?
Change of baudrate from 115k tot 38k4 does not succeed. i changed setting in configuration file but no result. Is there a way to change baudrate with direct commands to Telit module or other way?
Thank you, regards
Please login or Register to submit your answer
Staff replied 2 years ago
Hi Lupko,
Fixed/Floating jump usually have nothing to do with the Telit configuration, and usually have to do with your antenna / board installation.
Find a setting that you have stable FLOAT fix, 115’200bps is the right setting for the Telit, and once this is stable check:
– Antenna installation is good, using metal plates helps and following the recommendations: https://www.ardusimple.com/gps-gnss-antenna-installation-guide/
– Board is being using inside a box, to avoid direct airflow and sunlight.
– Check that your base station is not further than 35km from you.
replied 2 years ago
Thank you Staff for advices.
Unfortunately baudrate has to remain 115200.bps, nothing to do about that.
Best Regards,