Update (21/01/2022): We keep shipping worldwide and we have plenty of stock of all our products. Shop now.X

Ask a question

You need to be registered/logged in to make a question.

ClosedArdusimple answered 3 years ago • 
1005 views1 answers0 votes
The u-blox configuration was reset when updating the firmware
Closedt.m answered 3 years ago • 
1755 views2 answers0 votes
Unable to get UART1 output
Closedgeom asked 3 years ago • 
1906 views0 answers0 votes
USB Device Not Recognized
Closedmdbirley asked 3 years ago • 
824 views0 answers-1 votes
Sharing NMEA
ClosedKaupoi answered 3 years ago • 
2904 views3 answers0 votes
Enabling a Bluetooth Conexion
ClosedKen McGuire answered 3 years ago
2913 views4 answers0 votes
Powering simpleRTK2B from 3.3V.
ClosedArdusimple answered 3 years ago • 
691 views1 answers0 votes
F9P engineering samples
ClosedArdusimple answered 3 years ago • 
723 views1 answers0 votes
antenna connector specs
Closedclive1 answered 3 years ago • 
1006 views1 answers1 votes
Problems during the firmware update.
Closedamagro answered 3 years ago
1598 views1 answers0 votes
Using Mission Planner and Pixhawk with NTRIP
Closedamagro answered 3 years ago • 
2313 views3 answers0 votes
Change output rate
Closedrosagriculture answered 3 years ago • 
1348 views1 answers0 votes
Are Rx2 and Tx2 pins swapped?
Closederwin74 answered 3 years ago
781 views1 answers0 votes
I2C, Backup supply voltage accessible?
Closederwin74 asked 3 years ago
723 views0 answers0 votes