erwin74 asked 2 years ago
I have two questions to the modules pin connectivity:
- is backup supply voltage (pin 36) accessible
- is the I2C bus (pin 44/45) accessible over the pixhawk connector
If not, then it would be nice to make these pins accessible in the next board version.
Thanks in advance!
I’m second to that. I2c/SPI are handy when your micros only have 1 UART.
Hi erwin74, Vincent,
Backup supply voltage is connected to VCC, thus is not available for you to use it.
I2C bus is also not available in the board.